Product Description
LEASE MAKE SURE THAT YOU READ THE ENTIRE DESCRIPTION OF THIS PART AND WATCH THE INSTALLATION VIDEO! SEE VIDEO BELOW.
This part is NEW. Fits 2007-2021 Toyota Tundra LEFT side glass of the 3 panel slider ONLY. It is dark tint just like original equipment. Please check the windows remaining in your truck for the word Toyota stamped in one of the lower corners. If so this part is easily installed see video below. If you have any questions please contact technical support at (231)-263-3300.
This part is intended to be a PATCH cost effective repair. It is not intended to restore the vehicle to its original appearance.
This part is not widely understood by most auto glass installers and can only be purchased from Brads Auto Glass, no other vendor in the world has this part.
NAGS Number: FY95053PK5
CTRL Number: ECT1565S
Comes as photographed and is considered part of the description. Does not fit the CR Laurence aftermarket slider
YOU TUBE installation video below provides a helpful guide in setting expectations after watching video if you have further questions please call tech support at (231)-263-3300.
Product Videos
Custom Field
Product Reviews
4 Reviews Hide Reviews Show Reviews
-
Left glass
Spoke to Brad prior to ordering, friendly fellow and shipped glass same day. Installation took me about 30 minutes and saved me hundreds. Worth the money all day.
-
rear window left panel
Perfect fit, easy installation.
-
Tundra glass
Thanks Brad for the excellent installation video, glass fit was great and very happy with the product
-
Great solution for DYI fix
Everyone quoted me $500 to replace one panel. Seems like it's because they need to replace or remove the entire window. With this, I just needed to remove the glass that's hanging over any edges, clean the old glass surface, adhesive and place the glass. 3 things to keep in mind when doing it. 1 - make sure you clean the old glass and remove and pieces hanging out of the edge. 2 - Use good adhesive. I used 3m which is around $29. The kind in the video gave me a hard time because it was stiff and needed heating. 3 - DON'T put too much adhesive or it will come out of the edges and is not easy to remove.